CMC Jack Plate Accessories

Transom Washer Plates

Made of strong 3/8" 6061 T6 aluminum alloy (not cast aluminum), the CMC Transom Washer Plate can eliminate bolts "biting" into transoms and can more evenly distribute loads on high performance engines. Hole centers:

Top Plate- 12-7/8" (#20022)

Bottom Plate- 9-7/8" (#20032)

Transom Wedges/Set-Back Spacers

These two degree wedges are designed to give extra positive or negative trim. The wedges are used as an aid for boats with an insufficient transom angle or for boats having planning problems at low speed. The unique design of the CMC Transom Wedges allows you to also use them as set back spacers, by simply inverting 2, 4, or 6 sets. Hole design fits the same pattern as the Power-Lift transom bracket and standard motor mounting. SIZE 1/2" X 4" X 11-1/4"(#20122)

Button Switch

This weatherproof trim button switch is made of molded black with raised white letters. It can easily be wired to the PT-130 Power Tilt & Trim or Power-Lift wire assemblies. (#20220)

Water Pressure Gauge

We highly recommend that you have an engine water pressure gauge on your dash if you did not have one installed at the dealer.
The water pressure gauge is sealed and drip proof and is mounted in the dash of the boat. The gauge registers from 0-30 P.S.I. (#20320)