209 Cleat Series Top Mounting Plate

Top mount backing plate (optional) allows easy installation from above the deck. NOT FOR USE WITH LIFTING CLEAT!



Installation

Place the template (backing plate in the desired location. Make sure that there is adequate clearance for the Pop-Up or Pull-Up mechanism below the deck

Trace the cleat cut-out area and spot the small threaded hole. Do not spot the four mounting holes yet.

Cout out the cleat installation area.

Drill a 3/16" diameter hole for the #6 screw

Place cleat in cout out and spot the four mounting holes.

Remove the cleat and drill the four mounting holes.

Place the backing plate through the cut-out and install the #6 screw through the deck into the backing place. Be careful not to drop the backing plate down in the hull. Do not over tighten the #6 screw.

Replace the cleat into the cut-out and install the four mounting scres through the cleat and deck into the backing plate.